Because WD40® displaces moisture, it quickly dries out electrical systems to eliminate moisture-induced short circuits.
WD-40® protects metal surfaces with corrosion-resistant ingredients to shield against moisture and other corrosive elements.
WD-40® loosens rust-to-metal bonds and frees stuck, frozen or rusted metal parts.
WD-40® gets under grease, grime, and gunk. WD-40® non-aerosol formulas also dissolve adhesives, allowing easy removal of labels, tape, stickers, and excess bonding material.
WD-40®'s lubricating ingredients are widely dispersed and hold firmly to all moving parts.
Standard O-Rings are any belonging to the AS568 classification system.
If your O-Ring is measured in inches or fractions, it is almost certainly a Standard O-Ring.
Backup rings are designed to keep O-Rings from extruding. These Back-up Rings are produced in either a contoured design, OR split or solid, depending on your material choice. You will find stock materials such as Fluorocarbon (FKM, Viton®), Nitrile (BUNA), PEEK™, PTFE (Teflon®)
Square O-Rings also belong to the AS568 classification system. They are basically a standard O-Ring, but instead of round, they have a square profile.
They are interchangeable with Quad Rings, in most cases.
Standard O-Rings are any belonging to the AS568 classification system.
If your O-Ring is measured in inches or fractions, it is almost certainly a Standard O-Ring.
Backup rings are designed to keep O-Rings from extruding. These Back-up Rings are produced in either a contoured design, OR split or solid, depending on your material choice. You will find stock materials such as Fluorocarbon (FKM, Viton®), Nitrile (BUNA), PEEK™, PTFE (Teflon®)
Square O-Rings also belong to the AS568 classification system. They are basically a standard O-Ring, but instead of round, they have a square profile.
They are interchangeable with Quad Rings, in most cases.
Standard O-Rings are any belonging to the AS568 classification system.
If your O-Ring is measured in inches or fractions, it is almost certainly a Standard O-Ring.
Backup rings are designed to keep O-Rings from extruding. These Back-up Rings are produced in either a contoured design, OR split or solid, depending on your material choice. You will find stock materials such as Fluorocarbon (FKM, Viton®), Nitrile (BUNA), PEEK™, PTFE (Teflon®)
Square O-Rings also belong to the AS568 classification system. They are basically a standard O-Ring, but instead of round, they have a square profile.
They are interchangeable with Quad Rings, in most cases.