Tough operating conditions are no match for KLONDIKE gear oils. They are specially formulated for maximum protection, durability, and efficiency no matter what climate or conditions are prevalent. Only the finest technology available is used in manufacturing our premium synthetic gear lubricants. KLONDIKE robust formulations are designed for gears and differentials that place rigorous demands on fluid technology and require extreme temperature and pressure protection. Driveline components in today’s automotive and heavy duty vehicles have become increasingly stressed by increased engine output, higher operating temperatures, and extended service intervals. KLONDIKE’s advanced gear oil technology protects against severe wear while balancing fluid durability in heavy load conditions, including extended drain intervals when applicable.
Standard O-Rings are any belonging to the AS568 classification system.
If your O-Ring is measured in inches or fractions, it is almost certainly a Standard O-Ring.
Backup rings are designed to keep O-Rings from extruding. These Back-up Rings are produced in either a contoured design, OR split or solid, depending on your material choice. You will find stock materials such as Fluorocarbon (FKM, Viton®), Nitrile (BUNA), PEEK™, PTFE (Teflon®)
Square O-Rings also belong to the AS568 classification system. They are basically a standard O-Ring, but instead of round, they have a square profile.
They are interchangeable with Quad Rings, in most cases.
Standard O-Rings are any belonging to the AS568 classification system.
If your O-Ring is measured in inches or fractions, it is almost certainly a Standard O-Ring.
Backup rings are designed to keep O-Rings from extruding. These Back-up Rings are produced in either a contoured design, OR split or solid, depending on your material choice. You will find stock materials such as Fluorocarbon (FKM, Viton®), Nitrile (BUNA), PEEK™, PTFE (Teflon®)
Square O-Rings also belong to the AS568 classification system. They are basically a standard O-Ring, but instead of round, they have a square profile.
They are interchangeable with Quad Rings, in most cases.
Standard O-Rings are any belonging to the AS568 classification system.
If your O-Ring is measured in inches or fractions, it is almost certainly a Standard O-Ring.
Backup rings are designed to keep O-Rings from extruding. These Back-up Rings are produced in either a contoured design, OR split or solid, depending on your material choice. You will find stock materials such as Fluorocarbon (FKM, Viton®), Nitrile (BUNA), PEEK™, PTFE (Teflon®)
Square O-Rings also belong to the AS568 classification system. They are basically a standard O-Ring, but instead of round, they have a square profile.
They are interchangeable with Quad Rings, in most cases.